37 lines
1.7 KiB
Text
37 lines
1.7 KiB
Text
---
|
|
title: "Installing boot9strap (Homebrew Launcher)"
|
|
---
|
|
|
|
Als je je 3DS al eens eerder gehacked hebt met een op EmuNAND-gebaseerde CFW setup, deze handleiding zal zich alleen maar met sysNAND zich bezig houden, dus moet je alle instructies volgen vanuit of toepassend op SysNAND. Merk op dat de termen EmuNAND en RedNAND naar iets andere implementaties van [hetzelfde concept verwijzen](http://3dbrew.org/wiki/NAND_Redirection).
|
|
|
|
### Instructies
|
|
|
|
##### Section I - OCS
|
|
|
|
1. Press (A) to begin
|
|
1. Wait for the downloads to complete
|
|
1. Wait for the exploit to run
|
|
+ Hiervoor kunnen meerdere pogingen nodig zijn
|
|
+ If it freezes, just force the console to power off by holding the power button, then relaunch OCS to try again
|
|
+ If you get a "PM INIT FAILED" error, try replacing the `safehax.3dsx` file in the `/3ds/` folder on your SD card with the one from the [r19 release of safehax](https://github.com/TiniVi/safehax/releases/tag/r19)
|
|
1. If the exploit was successful, you will have booted into SafeB9SInstaller
|
|
|
|
##### Section II - Installing boot9strap
|
|
|
|
1. Wait for all safety checks to complete
|
|
1. When prompted, input the key combo given to install boot9strap
|
|
1. Once it has completed, press (A) to reboot your device
|
|
|
|
### Deel III - Luma3DS configureren
|
|
|
|
1. Your device should have rebooted into the Luma3DS configuration menu
|
|
+ If you get a black screen, [follow this troubleshooting guide](troubleshooting#ts_sys_b9s)
|
|
1. Use the (A) button and the D-Pad to turn on the following:
|
|
+ **"Show NAND or user string in System Settings"**
|
|
1. Druk op (Start) om op te slaan en opnieuw op te starten
|
|
+ If you get an error, just continue the next page
|
|
|
|
___
|
|
|
|
Continue to [Finalizing Setup](finalizing-setup)
|
|
{: .notice--primary}
|